-
Product Center
-
-
-
Unmanaged Industrial Switches(Extended Temp)
Unmanaged Industrial Switch
L2 Managed Industrial Switches
L3 Managed Industrial Switches
TSN Industrial Switch
Managed Industrial PoE Switch
M12 Industrial Switch
Industrial 100-Mbps Transceiver
Industrial Gigabit Transceiver
Unmanaged Switch
L2 Managed Switches
Standard PoE Switches
Non-standard PoE Switches
Managed PoE Switch
Unmanaged Domestic Switches
Managed Domestic Switches
Unmanaged Waterproof Switches
Managed Waterproof Switches
100M Fiber Optic Transceivers
Gigabit Fiber Optic Transceivers
Fiber Optic Transceiver Chassis
Pure Telephone Optical Terminals
Telephone&Ethernet Optical Terminals
Integrated Service Telephone Optical Terminals
HDMI Video Optical Terminals
SDI Video Optical Terminals
VGA Video Optical Terminals
DVI Video Optical Terminals
3.5mm Interface Audio Optical Terminals
RCA Interface Audio Optical Terminals
XLR Interface Audio Optical Terminals
Commercial-grade Dry Contact Optical Terminals
Industrial-grade Dry Contact Optical Terminals
RS485 Date Optical Terminals
E1 Over IP
Voier Over IP
Pure E1 Optical Terminals
1+1 Fiber Back-up Optical Terminals
4~30 Channels PCM Multiplexers
Ethenet Over 1~16*E1 Converters
1~32 Serial Port Servers
Industrial 4G Routers
Industrial 5G Routers
2.4G/5.8G Wireless Bridge
Wireless AC Controller
Gigabit Optical Modules
Power Adapter
Rail-Mounted Power Supply
Fiber Optic Pigtail
Terminal Box
GQ6002ZA-X-T/R
2-channel forward‑direction XLR audio optical transceiver
Keywords
Commercial Switches
Domestic Switches
隐藏域元素占位
Category:
Commercial Switches
Domestic Switches
Product Overview
The GQ6002ZA‑X‑T/R XLR‑to‑fiber audio optical transceiver enables bidirectional, long‑distance transmission of two balanced XLR audio channels over a single fiber optic cable. The device features professional‑grade 3‑pin XLR connectors, converting incoming audio signals into digital data, performing digital multiplexing, and then modulating the signal into an optical format for transmission. At the receiving end, photoelectric conversion is carried out, followed by demultiplexing and digital‑to‑analog conversion to restore the signal as an analog output.
Canon‑type (XLR) audio optical transceivers are divided into optical transmitters and optical receivers, which are used in pairs. They are widely employed in radio‑station audio transmission, live television broadcasting, live concert broadcasting, high‑definition video conferencing, film studios, distance learning, and other applications.
Product Features
1. Supports balanced audio transmission via two XLR connectors in the forward direction.
2. The optical port supports multimode or single-mode, single-fiber or dual-fiber, and is available with FC, SC, ST, or LC connectors.
3. The audio interface is a standard broadcast‑grade analog XLR balanced connector, with a high dynamic range of 100 dB.
4. Automatic high-pass filtering to isolate the DC offset.
5. Intelligent noise suppression system, designed for soft rising or falling ramps and analog noise reduction, with a 100 dB signal-to-noise ratio (SNR) and zero‑pop operation.
6. The audio interface features three-level lightning protection, meeting IEC 61000-4-5 (8/20 μs) standards: common-mode surge voltage of 6 kV.
7. Plug and play—no configuration required.
| Interface parameters | |
| Audio interface (XLR) | Signal level: 0–8 Vp-p Dynamic bandwidth: 101 dB Total Harmonic Distortion (THD): -90 dB Sampling frequency: 192 kHz Audio A/D sampling: 24 bits Signal-to-Noise Ratio (SNR): 100 dB Frequency response: ≤±0.5 dB Audio input/output impedance: 600 Ω balanced Maximum audio input/output voltage: 0–4 V / 0–2.5 V Audio gain: ±0.1 dB Maximum input level: ≥9.5 dBm Nonlinear distortion: ≤0.2% |
| Optical interface | Optical wavelengths: 850 nm, 1310 nm, 1550 nm Optical transmit power: > -7 dBm Receiving sensitivity: < -24 dBm |
| Number of interfaces | |
| Optical port | Quantity: 1 piece Interface types: FC, SC, ST, and LC are available. Transmission distance: Multimode fiber: 2 km; Single-mode fiber: 20/40/60/80/100 km |
| Audio interface | Audio channels: 2 forward channels Interface type: dual‑purpose XLR female connector (transmission), XLR male connector (reception) |
| Power Supply Characteristics | |
| Input voltage | DC-12V |
| Full-load power consumption | <2W |
| Wiring method | DC5525 power connector |
| Overload protection | Support |
| Work environment | |
| Operating temperature | -20～70℃ |
| Storage temperature | -40～85℃ |
| Relative humidity | 5% to 95% (non-condensing) |
| Mechanical Properties | |
| Shell | Metal casing |
| Installation Method | Desktop-style |
| Warranty | |
| Warranty period | Two years |
Device model | Business Interface | Optical port | Power supply |
GQ6002ZA-X-T/R | 2-channel forward‑direction XLR audio optical transceiver | 1 piece FC, SC, ST, and LC are available. | External power adapter |
| When placing an order, please confirm whether the optical port is multimode or single-mode, whether it uses a single fiber or dual fibers, and the transmission distance in kilometers. | |||
Application Diagram: Fiber Optic Point-to-Point Networking
Related Documents
Name
Size
Type
Release Date
Download
Beijing–Tianjin–Hebei, Henan, Shanxi, Inner Mongolia, and Sichuan:+8613719208595
Fujian, Guangxi, Hainan, Yunnan, Guizhou, and Jiangxi:+863760887412
Heilongjiang, Jilin, Liaoning, Inner Mongolia, Hunan, Chongqing:18126729399
Jiangsu, Zhejiang, Shanghai, Shandong, and Anhui:+8618198851696
Shaanxi, Gansu, Ningxia, Qinghai, Xinjiang, and Tibet:+8618198851697
Guangdong Region:+8613302232639 +8618903052902
3rd Floor, Elevator No. 1, Building B, Guangzheng Science and Technology Park, No. 11, Nanyun Fifth Road, Huangpu District, Guangzhou City